Fixture File - ADJ Jolt Panel FX2

Beam Fixture Profiles
1

Hi all,

HELP NEEDED.

I am very new to this but have had a fun couple of headscratching days trying to figure it all out. Here is my problem - I’m all connected via ODE Mk3 Art-net - Lights come on. Using generic.amxd. Monitor is showing output to the white1-6 channels I have on 40-45. when I raise red parameter - plus only partial RGB segments are lighting up - then there is some flickering. 2 lights both reacting the same way.

I am changing my leads as I have adapters from 5-3 pin (could it be that? Only 5 meter) and the terminals I bought were also 3 pin so tomorrow that bit will be definitely fixed). But Monitor still showing that something in my fixture file is not as it should be.

Tour in 10 days time - haha. I always do this - I am also the musician.

Cheers all

Henry

2

I have managed to make the 51 channel fixture work pretty good. I struggled with the 18 for a couple of days. 51 seems to work a bit better, there were some unexplained anomalies with OuterStrobeRate coming on when Beam wasn’t sending anything on that channel, never did get to the bottom of it (Amateur Hour). Just to add, the leads made no difference, it was of course in my fixture settings. This works now. Please enjoy if anyone needs it.

ADJ Jolt Panel FX2 - 51CH.sbf (13.2 KB)

Cheers

Henry

2 Likes